（清空日期可显示全部记录）
| 标准编号 | 标准名称 | 发布日期 | 实施日期 | 废止日期 | 替换信息 |
|---|---|---|---|---|---|
| UIC B12 DT 335:1997 | Constructional Provisions For Improved End Steps And Handrails, Taking Special Account Of Radio Remote-controlled Marshalling | ||||
| UIC B112 RP 11:1973 | Standard Report Form Intended For Use During The Acceptance Testing Of Large Containers And For The Possible Issue Of Certificates | ||||
| UIC B12 DT 389:2001 | Konstruktionsloesungen Fuer Die Seitliche Sicherung Von Warmgewalzten Blechrollen Auf Offenen Muldenwagen | ||||
| UIC B12 RP 12:1965 | Part 1: Economic Comparison Of The Use Of Oak Or Pine Floors For Wagons In Current Use - Part 2: Economic Comparison Concerning The Use Of Roofs Formed Of Steel Or Of Wood Covered With Waterproof Fabric Or Of Light Alloy | ||||
| UIC B12 RP 16:1969 | Standardisation Of The Air-brake Rigging Of Standard Wagons | ||||
| UIC B12 RP 13:1965 | Junction Boxes For Refrigerator Wagons And Mechanically Refrigerated Wagons | ||||
| UIC B12 RP 15:1968 | Results Of Corrosion Tests On Various Types Of Copper Bearing And Non-copper Bearing Steel Plate | ||||
| UIC B12 RP 14:1967 | Standard Bogie | ||||
| UIC B12 RP 10:1964 | Determination Of Heat Transfer Through Roofs And Walls Of The Type 1 Covered Vans | ||||
| UIC B12 DT 85:1996 | Allgemein Verwendbare Bauteile Und Richtlinien Fuer Den Bau Von Gueterwagen | ||||
| UIC B12 DT 50:1979 | Einheitliche Gestaltung Des Wagenendes, Aufgestellt Vom Sva B 12 | ||||
| UIC B12 RP 3:1959 | Results Of The Static And Dynamic Tests Carried Out On The Prototype Wagons | ||||
| UIC B12 RP 25:1986 | Flexibility Of Trapezoidal Springs | ||||
| UIC B12 RP 1:1956 | First Report On The Work Of Standardisation Of Wagons And Description Of Standard Of Established Classical Design | ||||
| UIC B12 RP 27:1978 | Standardisation Of Cast-steel Bogies Suitable For Use In S And Ss Traffic | ||||
| UIC B12 RP 29:1979 | The Influence Of The Strain Rate On The Yield Point Of Steel - Effect Of Repeated Impacts On The Yield Point Of The Steel | ||||
| UIC B12 DT 419:2010 | Simulation Calculations To Ascertain The Safe Running Of Wagons Fitted With Draw Bars - 1St Interim Report: Obb Verification | ||||
| UIC B12 DT 424:2011 | Wagons Simulation Calculations To Ascertain The Safe Running Of Wagons Fitted With Draw Bars 2Nd Interim Report: Variant Calculation | ||||
| UIC B12 RP 23:1975 | Standardisation Of A Bogie With The Brake In The Under Frame For Ss-traffic | ||||
| UIC B12 DT 80:1995 | Allgemeine Bestimmungen Fuer Die Erstellung Eines Lastenheftes Und Die Ueberpruefung Der Technischen Konstruk- Tionsunterlagen Fuer Gueterwagen Liste Der Referenzdokumente | ||||
| UIC B12 RP 24:1976 | Covered Bogie Wagon, Type Gabbs | ||||
| UIC B12 RP 21:1985 | Open Bogie Wagons | ||||
| UIC B12 RP 22:1977 | Bogie Van With Sliding Walls, 'habiss' | ||||
| UIC B12 RP 20:1973 | Flat Bogie Wagon, Type 1 | ||||
| UIC B12 RP 2:1956 | Report On The Activities Of The Jury For The Design Competition For The Wagon Of The Future' - Volume 1: Results Of The Competition And Conclusions - Volume 2: Memorandum On The Work And Technical Discussions Of The Jury For The Design Competition For The Wagon Of The Future And Appendices | ||||
| UIC B12 RP 45:1987 | Tests Carried Out On The Uic Suspension Gear For Two-axle Wagons With A View To Increasing The Axle Load From 20 T To 22.5 T | ||||
| UIC B12 RP 18:1972 | Conversion Of Standard Wagon Under- Frames So As To Make Them Suitable For Subsequently Taking The Automatic Buffing And Draw Coupler | ||||
| UIC B12 RP 19:1972 | Flat Bogie Wagon, Type 2 | ||||
| UIC B12 RP 42:1986 | Structural Modifications To The Standard Bogie | ||||
| UIC B12 RP 37:1983 | Adaptation Of Wagon Bogies To A 22.5 T Axle-load At A Speed Of 100 Km/h Static And Dynamic Tests On Bogie Frames | ||||
| UIC B12 RP 40:1984 | Propelling Tests With Long Two-axled Wagons | ||||
| UIC B12 RP 44:1986 | Bogies Suitable For An Axle-load Of 22.5 T; Standardisation | ||||
| UIC B12 RP 41:1986 | Line Tests On Bogies, Which Are To Take An Axle-load Of 22.5 T: Y25 L Sncf, Y25 L Br/pkp, 650.2 | ||||
| UIC B12 RP 39:1984 | Recess Wagons (sdkkmss) For Rail Transport Of Semi-trailers, Swap Bodies And Containers In Block Trains | ||||
| UIC B12 RP 43:1988 | Parabolic Springs For Wagons (design, Calculation, Treatment) | ||||
| UIC B12 RP 36:1984 | Bogie Wagon With Opening Roof Type Taems | ||||
| UIC B12 RP 58:1994 | Relative To Two-axled Wagons In Train Formation And Negotiating Track Sections With Small-radius S-curves And Short Straight Intermediate Sections, Studies Of The Permissible Longitudinal Compressive Forces Resulting From Braking Forces And Pushing Forces From Low Speeds | ||||
| UIC B12 RP 35:1983 | Part 1: Standardisation Of A Bogie With Cast Steel Frame, With Built-in Brake Cylinder And Brake Gear Adjuster, Suitable For Use At 100 Km/h - Part 2: Bogie Operated Hand Brake, Used On Standard Bogies With Built- In Brake Cylinder And Brake Gear Adjuster, Suitable For Use At 100 Km/h | ||||
| UIC B12 RP 59/1:1996 | Part 1: Further Development Of The Medyna Program For Ride Safety Studies With Freight Wagons In Three-wagon-sets | ||||
| UIC B12 RP 53:1992 | Study Of Type 1 And 2 Standardized Flat Bogie Wagons Regarding Increasing The Permissible Axle Load To 22.5 T (rens/remmns) | ||||
| UIC B12 RP 5:1961 | Results On The Static And Dynamic Tests Carried Out On The Prototype Vans | ||||
| UIC B12 RP 54:1992 | Reduction In The Aerodynamic Drag Of Wagons | ||||
| UIC B12 RP 48:1989 | Partial Standardisation Of Certain Features Of The Sliding Wall Wagons For 22.5 T Axle Load Hbi(2)ns (type 1a And 1b Of Uic Leaflet 571-3) And Hbbi(2)ns (type 2a And 2b Of Uic Leaflet 571-3) | ||||
| UIC B12 RP 56:1994 | Standardization Of The Y 25 Bogie With Radially Adjustable Wheel Sets | ||||
| UIC B12 RP 52:1992 | Standardization Of A Sliding Synthetic Cover For Type Shimm(n)s Bogie Wagons With Fixed Endwalls And Loading Cradles | ||||
| UIC B12 RP 47:1988 | Tests On The Running Gear Of Existing Wagons To Assess Their Suitability To Run At A Maximum Speed Of 100 Km/h | ||||
| UIC B12 RP 50:1990 | Studies On The Bogies Of Existing Wagons In Connection With Their Suitability Or Adaptation For A Maximum Speed Of 100 Km/h | ||||
| UIC B12 RP 64/3:1995 | Revision Of The Buffing Test Conditions In Report B 12/rp 17 (section 3.1) - Volume 3: Confirmation Tests For The Purpose Of Revising The Buffing Test Conditions | ||||
| UIC B12 RP 64/1:1995 | Revision Of The Buffing Test Conditions In Report B 12/rp 17 (section 3.1) - Volume 1: Analysis Of The Questionnaire Sent To The Railways And Private Wagon Owners Concerning The Fitting Of Wagons With Buffers And The Handling Of Wagons During Marshalling Operations | ||||
| UIC B12 RP 63:1995 | Standardization Of The Screw Coupler |
若您对上表中数据有任何疑问，请与网站联系。
